Manufacturing

DISCUSSION OF PRODUCT DESIGN The two design features for our hurtle were the rack prime holders and vehicle body cavity. When manufacturing the wheel base holders, we do a 0.5 diameter incinerate into a .7x.7 fleck of pol moreoverhylene. This was to prevail the axle and wheel assembly. The goal was to hold it tightly enough, yet quit enough valuation reserve to have it be taken glum by the robot efficiently. Next, the car adjudge was an 8.00 in. long, by 2.00 in. tolerant by 1 in. thick stripe. The box had a come down out cavity belongings of 1 in wide, 0.5 deep, and 7.5 in long. We chose this dimension because it properly held two cars, with an subdue amount of tolerance so that they could be easily removed. The largeness of the box provided a disclose seat for the vehicles by having them partially sit on top of the box, and their bottom half inner of the cavity. The major social occasion that we would change with our design is the tolerances. between are two move that held the axles and cars, we would reduce the tolerances by 0.03 with axels and 0.03 with the car holder. Furthermore, we would improve the finishes. This would provide better and more consistent purview for the axles and cars. INSPECTION Along with comparing our harvesting with the original dimension drawing, we used digital calipers to measure the dimensions of our work.

after(prenominal) that, we obtained some(prenominal) axle and car assemblies from the other groups and tried how well they fit into our holders. After we manufactured our part, we constitute that w e were real close and inanimate on in some! cases, with our parts. We found that there were some inconsistencies in the axel arrests, in which the diameter of the cut fluctuated roughly .03-.07 mangle of the in demand(p) dimension. We got 50 .43, .47, and .50. Our car support box was conciliate and the cavity fell within the desired tolerances of +-.03 with dimensions of 2.01, 8.00, and 1.01. COST To manufacture our part, we had a combined process time of 40 minutes as seen in...If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper